45
Cleaning and Maintenance
❏
In order to maintain cooling power, only fit
one set of filters onto the support.
Note
The flaps on these models are fitted with
safety stops up to which point they can be
opened without risk of the front flap falling
and causing damage and/or injury. The flap
on the appliance can be removed (firmly
pull the flap towards you) to make it easier
to clean and change the filters. Afterwards,
or should for any reason the flap come out
of its original housing, proceed as follows
to fit it:
1° Lift the flap until it comes out of its
lower supports, (Fig. 22: a).
2° Position the plastic leg in the front
groove on the appliance (in T position)
and slide it down to the safety stop,
(Fig. 22: b).
3° Fit the lower studs in the front stops
on the appliance making sure that the
plastic leg fitted in the previous step
does not come out of position,
(Fig. 22: c).
When finished, the user should make sure
that the flap is fitted properly and does not
fall when opened again. (The door opens
up to the safety stop). If not fitted properly,
repeat steps 1° and 2° again.
a
b
Transportation requirements
The appliance is fitted with wheels to make it
easier to move around. It can be tilted, if
necessary, in order to make transportation
easier. You should not turn the appliance back
on again for a minimum period of one hour
after performing this procedure.
❏
Before tilting it, empty the condensed water
from the internal tank by extracting the
water drainage pipe from its housing and
removing the plug, Fig. 23. Place a
receptacle (or the appliance’s removable
tank) at the end of the water drainage pipe
to collect the condensed water or lead the
pipe to the nearest drain. Do not forget to
replace the plug and reinsert the pipe in its
housing when the tank is empty.
Fig. 23
Fig. 22
