3 - 1
Siemens-Elema AB
Register 5
SPB7-230.092.11
Page 1 of 8
MAMMOMAT 3000 Modular
Solna, Sweden
Rev. 01
04.98
SPS-UD
Service
Installation
3
Installing the new filter assembly
3
See figure 2.5 and 3.1.
1.
Position the new filter assembly so that the cog disc engages with the motor
pinion (12) and the rear guide. The angular position of the filter assembly in
relation to the motor pinion is arbitrary.
2.
Install the two front guides (10).
3.
Install the bearing (9) and secure with the retaining ring (8).
Fig. 3.1 Position sensor and drive motor of the filter assembly
Reinstalling the diaphragm-plate assembly
3
See figure 2.2 and 2.3.
1.
Fit the diaphragm-plate assembly (5) to the diaphragm-plate holder, while
carefully putting the lamp holder into position, and fasten with the four Allen
screws (6).
2.
Fit the lamp holder (4) to the diaphragm-plate holder and fasten with the two Allen
screws (3).
3.
Replace the cable ties that were cut during the removal of the diaphragm-plate
assembly.
Do not touch the filters with bare fingers. Use lint-free cotton
gloves. Be careful not to damage the optical switch position
sensor (11) during the installation.
Be careful with the filter assembly.
NOTICE
11
Drive motor
MA
M001
54
NOTICE