Siemens LD97AA670, Instruction Manual

Page: 16 / 96

16
Opening the filter cover
1. Fold the filter cover forwards.
2.
Lift the filter cover forwards.
Removing metal mesh grease filter
1. Open the metal grease filter lock and remove the filter from
the holder.
Note: Grease can collect in the bottom of the filter holder.
Hold the filter holder at an angle to prevent grease from
dripping out.
2. Clean the metal grease filter and filter cover.
3. After removing the filters, clean the inside of the appliance.
Changing the activated charcoal filter (only in circulating-air
mode)
1.
Hold the edge of the metal clip firmly and pull towards the
middle of the filter.
2.
Take the metal clip out of the holder.
3. Disconnect the activated charcoal filter from the metal grease
filter.
4. Secure the activated charcoal filter back to the metal grease
filter with the metal clip.
Installing the metal mesh grease filter
1.
Fit the metal grease filter.
2. Fit the filter cover.
Trouble shooting
Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
LED lights
Defective LED lights must only be replaced by the
manufacturer, their customer service department or a licensed
technician (electrician).
What to do if water gets in
If water gets in to the appliance during cooking or cleaning,
proceed as follows:
1. Switch off the appliance.
2. Open the floor cupboard and mop up leaking water.
3. Leave the appliance switched off for 24 hours.
After this time, the appliance can be used again without
restrictions.
Malfunction table
--------
Problem Possible cause Solution
The appliance
does not work The plug is not
plugged in. Connect the appliance
to the electricity supply
Power cut Check whether other
kitchen appliances are
working
Faulty fuse Check in the fuse box to
make sure that the fuse
for the appliance is OK
Appliance does
not switch on.
Filter cover not
closed.
Close the filter cover
fully.
The button illu-
mination does
not work.
The control unit
is faulty. Call the after а sales serv-
ice.
The lighting
does not work.
The bulbs are
faulty.
Call the after а sales serv-
ice.
If
ª
or
’
appears on the
display
The grease or
activated char-
coal filter is sat-
urated.
Clean the filter – see
section "Cleaning and
maintenance".