en
28
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Possible cause
Remedial action
Temperature differs
greatly from the set
value.
In some cases it is adequate to
switch off the appliance for
5 minutes.
If the temperature is too high wait a
few hours and check whether the
temperature has approached the set
value.
If the temperature is too low check
the temperature again the next day.
The light does not
work.
The bulb is defective.
Replace bulb. Fig.
,
/B
1. Switch the appliance off.
2. Pull out mains plug or switch off
fuse.
3. Remove bulb cover from the rear.
4. Change the bulb.
(Replacement bulb:
220-240 V a.c., E14 bulb holder,
see defective bulb for wattage.)
Light switch is
jammed.
Check whether it can be moved.
Fig.
,
/A
Bottom of the
refrigerator
compartment is wet.
The condensation
channel or drainage
hole are blocked.
Clean the condensation channel
and the drainage hole. See chapter
Cleaning the appliance. Fig.
+
The temperature in the
refrigerator
compartment is too
cold.
Temperature has been
set too low.
Increase the temperature.
Summary of Contents for KF R Series
Page 70: ...1 2 6 1 4 7 8 10 9 11 5 12 0 2 4 1 2 3 4 6 8 super C 3 ...
Page 71: ...3 4 5 6 7 8 A ...
Page 72: ...8 B 9 B A 0 2 3 4 6 8 super C ...
Page 73: ... ...
