Siemens KD7 N Series, Operating Instructions Manual

Page: 25 / 44

en
25
Cleaning the
appliance
1. Attention: Pull out the mains plug or
switch off the fuse!
2. Wipe the door seal with water only and
then dry thoroughly.
3. Clean the appliance with tepid rinsing
water. The rinsing water must not drip
onto the fascia or light.
4. After cleaning: reconnect and switch on
the appliance.
t~êåáåÖW
kÉîÉê=ìëÉ=~=ëíÉ~ã=ÅäÉ~åÉê=íç=ÅäÉ~å=íÜÉ=
~ééäá~åÅÉK=píÉ~ã=ã~ó=ÅçãÉ=áåíç=Åçåí~Åí=
ïáíÜ=ÉäÉÅíêáÅ~ä=ÅçãéçåÉåíë=~åÇ=Å~ìëÉ=
~ ëÜçêíJÅáêÅìáí=çê=~å=ÉäÉÅíêáÅ=ëÜçÅâ>=
qÜÉ ëíÉ~ã=ã~ó=Ç~ã~ÖÉ=íÜÉ=éä~ëíáÅ=
ëìêÑ~ÅÉëK
aç=åçí=ìëÉ=~Äê~ëáîÉ=çê=~ÅáÇáÅ=ÅäÉ~åáåÖ=~ÖÉåíë=
~åÇ=ëçäîÉåíëK
qÜÉ=êáåëáåÖ=ï~íÉê=ãìëí=åçí=êìå=áåíç=íÜÉ=
îÉåíáä~íáçå=çéÉåáåÖ=çå=íÜÉ=ÇççêK
kÉîÉê=ÅäÉ~å=íÜÉ=ëÜÉäîÉë=çê=Åçåí~áåÉêë=áå=íÜÉ=
ÇáëÜï~ëÜÉêK=qÜÉ=é~êíë=ã~ó=ï~êé>
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice, even if the appliance is still under guarantee!
Fault Possible cause Remedial action
A fault code (e. g.
E01
) is
indicated on the display.
The appliance has detected a fault
during an automatic self-test. Call customer service and
report the fault code.
Interior light does not
function;
the refrigerating unit is
running. The bulb is defective. Replace bulb.
1. Pull out the mains plug or
disconnect the fuse.
2. Change the bulb
(Replacement bulb, 220-240V
a.c., E14 bulb holder, see
defective bulb for wattage).
The temperature
in the refrigerator
compartment is too
cold. Temperature has been set too
low. Increase the temperature.
If large quantities of fresh food
are being frozen, the
temperature in the refrigerator
compartment drops temporarily,
as the refrigerating unit runs for a
long time. Do not exceed max. freezing
capacity.
Refrigerator has no
cooling capacity. Power failure; the fuse has been
switched off; the mains plug has
not been inserted properly. Check whether the power is
on, check the fuses.