Cleaning function
en
29
■
First rinsing cycle (approx. 6-9 minutes), then empty
and refill the water tank
■
Second rinsing cycle (approx. 6-9 minutes), then
empty and dry the water tank
If the descaling process is interrupted (for example, due
to a power failure or because the appliance has been
switched off), you are prompted to rinse the appliance
twice after it is switched back on. The appliance cannot
be used until the second rinsing cycle has come to an
end.
The frequency with which the appliance must be
descaled depends on the hardness of the water used.
When only five more steam-assisted operations are
possible, or fewer, the appliance reminds you to
descale it with a message on the display. The number
of remaining operations is displayed after the appliance
is switched on. You can therefore prepare for the
descaling in good time.
Starting
Caution!
Damage to the appliance: Only use liquid descalers
recommended by us for the descaling programme.
Other descalers may damage the appliance.
Descaler order no.: 311 680
Caution!
Descaling solution: Do not allow the descaling solution
to come into contact with the control panel or other
sensitive surfaces. This will damage the surfaces. If this
does happen, remove the descaling solution
immediately with water.
The descaling programme can only be started once the
cooking compartment has completely cooled down. If
the temperature in the cooking compartment is too
high, a message appears on the display. Wait until the
cooking compartment has cooled down. Then restart
the process.
If you have used a steam-assisted operation
immediately before descaling, you must first switch the
appliance off so that the residual water is pumped out
of the evaporator system.
1.
Mix 500 ml water with 150 ml liquid descaler to
make a descaling solution.
2.
Press the On/Off button.
3.
Remove the water tank and fill with descaling
solution.
4.
Fully insert the water tank filled with the descaling
solution.
5.
Close the control panel.
6.
Press the Menu button.
The operating modes menu opens.
7.
Select the Descale operating mode.
If you touch the "Next" field, information on the
cleaning operation is displayed.
The duration of the descaling programme is
displayed. It cannot be changed.
8.
Press the "Start/Stop" button to start the cleaning
operation.
The appliance is descaled. You can see the duration
counting down in the status bar. As soon as the
descaling programme has finished, an audible
signal sounds.
First rinsing cycle
1.
Open the control panel.
2.
Remove the water tank, rinse thoroughly, fill with
water and reinsert.
3.
Close the control panel.
4.
Press the Start/Stop button to start.
The appliance rinses. As soon as the rinsing cycle
has run through, a signal sounds.
Second rinsing cycle
1.
Open the control panel.
2.
Remove the water tank, rinse thoroughly, fill with
water and reinsert.
3.
Close the control panel.
4.
Press the Start/Stop button to start.
The appliance rinses. As soon as the rinsing cycle
has run through, a signal sounds.
Final cleaning
1.
Open the control panel.
2.
Empty and dry the water tank.
3.
Switch off the appliance.
Descaling is complete and the appliance is ready for
use again.
