3/8
Key Name
Description
One-shot-sewin
g selection
In constant-stitch sewing
：
a. One shot to the pedal, automatic performed number of stitches of every
section.
b. Toe down the pedal again and again to finish rest the sections until it finish pattern.
Free sewing
1). As the pedal is toed down, machine will start sewing. Once the treadle returned to neutral,
machine will stop immediately.
2). As the pedal heeled back, the trimming cycle will be finished automatically.
Multi-section
constant-stitch
sewing
Also known as fixed length seam, press this key, the system is to enter a multi section seam work
mode. The LCD screen
is lit and displayed on the n X yy, where X is the current segment, the
maximum 15 segment can be set, YY is the current number of pins, the maximum 99 pin can be set.
If the current number of X is set to 00, the total number of valid segments is (X-1).
Presser foot
lifting Mode
Switch during all presser foot lifting mode when pressing the key. (No lifting, lifting after trimming
cycle
only, lifting at machine stop
only, lifting at machine stop
and after trimming
cycle
both).
Trimming cycle
selection
Enable or disable the trimming cycle.
Start back
tacking setting
key
Switch during all start tacking type when pressing. (No tacking, once tacking , double tacking
, 4
repeat tacking
). Tacking stitches A
、
B can be set using the
key and the
key.
End back
tacking setting
key
Switch during all end tacking type when pressing. (No tacking, once tacking , double tacking
, 4
repeat tacking
). Tacking stitches C
、
D can be set using the
key and the
key.
Stop position
key
When sewing midway stop, system upper / lower needle stop position by pressing the key,
is lit,
that is up needle stop position, then press the key, show down needle stop. the sewing complete
trimming, the system will stop up needle position. Note: the H-43 panel without the key, the key
P
+
combination to achieve the function.
Custom function
key
Special function according to the custom requirement.
Increasing and
decreasing
motor speed
The maximum motor speed can be adjusted using the keys.
Up and down
keys
Adjust the values in plus and minus state.
Soft start setting
key
Soft start at the first seam is enabled (icon on) or disabled.
