boards.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
3-313
Nur für den internen Gebrauch
Boards for HiPath 3000
Peripheral boards
3.3.39
TMDID (for U.S. only)
Introduction
The TMDID board (Trunk Module Direct Inward Dialing) provides direct inward dialing from the
central office (CO) to HiPath 3800.
The board has eight trunk circuits that connect to analog trunks.
The circuits can be set up for Immediate Start or Wink Start.
Switches
●
Switches for manual trunk selection. In this case, all trunks are filtered one after the other
until the LED of the desired trunk flashes.
●
Lockout switch which can be used to manually block the selected trunk circuit.
LED statuses and their meanings
>
NOTE
Danger of damage to property due to surge voltage. The required lightning protec-
tion measures must be taken for this board, see Section 2.1.2, “Lightning Protec-
tion”.
>
The peripheral board slots on the HiPath 3800 are fitted with SIPAC 9 SU connec-
tors. Since the TMDID board has SIVAPAC connector strips, you will have to install
a SIVAPAC-SIPAC board adapter in order to be able to use it in HiPath 3800.
For information on this procedure, please see Section 4.1.5.5.
Table 3-152
TMDID (for U.S. only) - LED Statuses
LED status
0 - 7
Meaning
Off
The trunk circuit is free.
On
The trunk circuit is assigned.
Slow flashing
The trunk circuit was deactivated by the software.
Fast flashing
The switch was pressed and the trunk circuit was selected for manual acti-
vation or deactivation.
Summary of Contents for HiPath 3000 Series
Page 1252: ......
