HiPath1120, Installation Guide
3-17
Installation
HiPath 1120 wall mounting instructions
3.6
HiPath 1120 wall mounting instructions
Back of the enclosures
Figure 3-4
Installing the HiPath 1120
3.7
Installing modules
3.7.1
Configuring the HiPath 1100
For each configuration, please consider capacities, availability of modules and their respective
features and requirements.
Step
Procedure
1.
Drill a hole in the wall at a height of 4.10 ft from the floor.
2.
Place the bushing over the hole then insert the screw and tighten it until only 0.19"
protrude.
3.
Hang the system at the top of
➀
, on the screw (see figure 3-4).
4.
Mark additional holes for washers
➁
and remove the system.
5.
Drill the remaining holes as marked, install washers and screws then tighten them
letting 0.19" protrude.
6.
Hang the system again and align it by tightening the lower screws.
