17
Attaching the rail
1.
Position the rail so that the indentations are facing upwards.
2.
Hook the rail in at the back and push it towards the rear until
it engages (fig. C).
3.
Hook the front of the rail onto the holder and press down until
it engages and is fixed level in place in the appliance once
more (fig. D).
Each set of rails only fits on one side.
Troubleshooting
Malfunctions often have simple explanations. Please read the
following instructions before calling the after-sales service.
Repairs may only be carried out by fully trained after-sales
service technicians. Incorrect repairs to your appliance may
present considerable risks for the user.
:
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
'
&
Problem
Possible cause
Notes/remedy
The appliance does not work
The plug is not plugged into the mains
Connect the appliance to the electricity
supply
Power cut
Check whether other kitchen appliances
are working
Faulty circuit breaker
Check in the fuse box to make sure that
the circuit breaker for the appliance is OK
Faulty operation
Switch the appliance off using the circuit
breaker in the fuse box. Wait approxi-
mately 10 seconds and then switch it back
on
Appliance does not start.
Nx
‹
:
…‹
min
appears in the display
Descaling has been cancelled
Turn the operating mode selector to
È
and rinse the appliance twice
(see section: Cancelling descaling)
The appliance cannot be started
The appliance door is not fully closed
Close the appliance door
The appliance is not in operation. A cook-
ing time is shown in the display
A control knob was unintentionally
pressed
Press and hold the
J
|
"
button
The
J
|
"
button was not pressed after
setting
Press the
J
|
"
button briefly to start the
cooking operation, or press and hold the
J
|
"
button to cancel the setting
0
and
‹
:
‹‹
light up in the display
Power cut
Reset the clock time (see section: Time-
setting options)
The
¯
indicator appears even though the
water tank is full
The water tank has not been inserted
properly
Slide in the water tank until it locks into
place.
The detection system is not working
Call the after-sales service
The
¯
indicator appears even though the
water tank is not yet empty, or the water
tank is empty but the
¯
indicator does not
appear
The water tank is dirty. The moving water
level indicators are jammed
Shake and clean the water tank. If the
parts cannot be released, obtain a new
water tank from the after-sales service
The water tank empties for no discernible
reason. The evaporator dish overflows
The water tank was not closed properly
Close the lid until you feel it lock into place
The tank lid seal is dirty
Clean the seal
The tank lid seal is defective
Obtain a new water tank from the after-
sales service
The evaporator dish has boiled empty
even though the water tank is full.
The water tank has not been inserted
properly
Slide in the water tank until it locks into
place
The feed line is blocked
Descale the appliance. Check whether the
water hardness range is set correctly
The
¯
indicator appears
The appliance has not been used for at
least 2 days and the water tank is full
Empty and clean the water tank. Always
empty the water tank after cooking
