24
Quick Start Guide
Gigaset SX685 WiMAX / de-en / A31008-N917-R101-2-ZD43_23-10-2008 / qig_SX686_685.fm / 23.10.2008
Te
m
plat
e 2004
_12
_27
Connecting to the mains power supply
The system starts up and performs a self-test. After the self-test, the Gigaset SX685
WiMAX continually attempts to register with a WiMAX network. Registration may be
successful immediately. If not, registration will take place when the Gigaset SX685
WiMAX is being configured. You can check whether your device is already registered
with a WiMAX network via the
Status
LED.
Checking the operating state
Your Gigaset SX685 WiMAX is now ready for use. The LED displays on the front panel of
the Gigaset SX685 WiMAX provide information about the operating state.
When the device is ready for use, the LEDs light up as follows:
u
The
Power
LED on the front lights up green.
u
If registration with a WiMAX network has already been successful, the
Status
LED
lights up green. The
RSSI 1
-
RSSI 4
LEDs indicate the signal strength.
If the
Status
LED does not light up, register your Gigaset SX685 WiMAX during con-
figuration.
u
The
LAN
LEDs light up if a device is connected to the corresponding LAN port.
If this is not the case, refer to the section entitled Troubleshooting in the operating
instructions on the suppied CD.
Please remember:
Only use the mains adapter supplied with the device (12V DC 2A).
ì
Connect the mains adapter cable
to the
Power
socket on the
Gigaset SX685 WiMAX.
ì
Plug the mains adapter into a
mains socket.
The Gigaset SX685 WiMAX is now
switched on and ready for operation.
