en
Basic operation
14
Ice cube tray
Use the ice cube tray to make ice
cubes.
Making ice cubes
1.
Fill the ice cube tray with water up
to ¾ and place in the freezer com-
partment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
2.
To loosen the ice cubes, twist the
ice cube tray slightly or hold it
briefly under flowing water.
Basic operation
7 Basic operation
Basic operation
7.1 Switching on the appli-
ance
1.
Press .
a
The appliance begins to cool.
a
A warning signal sounds and
lights up because the freezer com-
partment is still too warm.
2.
Switch off the warning signal with
.
a
goes out as soon as the set
temperature has been reached.
3.
Set the required temperature.
→
7.2 Operating tips
¡
Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the temperature has
been reached.
¡
The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡
When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶
Press .
7.4 Setting the temperature
Setting the freezer compartment
temperature
▶
Press / repeatedly until the
temperature display shows the re-
quired temperature.
The recommended temperature in
the freezer compartment is
−18 °C.
Additional functions
8 Additional functions
Additional functions
8.1 Automatic Super freezing
The automatic Super freezing auto-
matically switches on when warm
food is placed in the compartment.
With automatic Super freezing, the
freezer compartment cools down to a
much lower temperature than for nor-
mal mode.
If the automatic Super freezing is
switched on,
lights up and in-
creased noises may occur.
After operation, the appliance
switches from automatic Super freez-
ing to normal operation.
Cancelling automatic Super freezing
▶
Press
.
a
The previously set temperature is
displayed.
