F S - 2 5 0 P R O G R A M M I N G M A N U A L
21
Starting Quick Test
The Quick Test mode allows quick and easy testing of the installation. It will allow
the devices to be activated and the NACs to sound for a short period of time.
Press “Quick
Test”
Press “Start”
The display will
prompt for a “Yes” or
“No” confirmation to
start Quick Test
Press “Yes” to start Quick Test.
The display will show NAC sound
time and the status of the printer
and the time till autoexit.
Configuring NAC sound time for Quick Test
The period of time that the NACs will be active after each event in Quick Test is set
as follows.
Press “Quick
Test”
Press
“Configure”
Press “NAC
time”
The display will
indicate the time
in seconds that
the NACs will
sound during
Quick Test.
Use the “Inc”
and “Dec”
buttons to set
the time from “0”
off and 1 to 30
seconds
Configuring the printer during Quick Test
Printing may be enabled or disable during Quick Test as follows;
Press “Quick
Test”
Press
“Configure”
Press “Printer”
The display will
indicate whether
the printer is
enabled or
disabled during
Quick Test
Use the
“Enable/Disable”
button to change
state. The display
will toggle to
indicate the state
Programming a device
It is possible to program a device address without the programming tool. Following
is the procedure
Press “more” twice
then Press
“Program device”
The panel will
display a
message as it is
looking for the
new device
When a new
device has been
found the display
will show a
screen to enter a
device address
Use the keypad,
the “Clr” and
“Program” buttons
to enter the
address and
program the new
device.
Summary of Contents for FireSeeker FS-250
Page 2: ......
