CAUTION
Noncompliance with the following safety regulations
Risk of injury to persons and damage to property
●
Compliance with the following regulations is required.
●
Specialist electrical engineering knowledge is required for installation.
●
Only an expert is permitted to carry out installation work.
Incorrect installation can take safety devices out of operation unbeknown to a
layperson.
Mounting, installation, commissioning and maintenance
●
If you require tools such as a ladder, these must be safe and must be intended
for the work in hand.
●
When starting the fire control panel ensure that unstable conditions cannot
arise.
●
Ensure that all points listed in the 'Testing the product operability' section below
are observed.
●
You may only set controls to normal function when the product operability has
been completely tested and the system has been handed over to the customer.
Testing the product operability
●
Prevent the remote transmission from triggering erroneously.
●
If testing building installations or activating devices from third-party companies,
you must collaborate with the people appointed.
●
The activation of fire control installations for test purposes must not cause
injury to anyone or damage to the building installations. The following
instructions must be observed:
–
Use the correct potential for activation; this is generally the potential of the
building installation.
–
Only check controls up to the interface (relay with blocking option).
–
Make sure that only the controls to be tested are activated.
●
Inform people before testing the alarm devices and allow for possible panic
responses.
●
Inform people about any noise or mist which may be produced.
●
Before testing the remote transmission, inform the corresponding alarm and
fault signal receiving stations.
Modifications to the system design and the products
Modifications to the system and to individual products may lead to faults,
malfunctioning and safety risks. Written confirmation must be obtained from
Siemens and the corresponding safety bodies for modifications or additions.
Modules and spare parts
●
Components and spare parts must comply with the technical specifications
defined by Siemens. Only use products specified or recommended by
Siemens.
●
Only use fuses with the specified fuse characteristics.
●
Wrong battery types and improper battery changing lead to a risk of explosion.
Only use the same battery type or an equivalent battery type recommended by
Siemens.
●
Batteries must be disposed of in an environmentally friendly manner. Observe
national guidelines and regulations.
Safety
Safety regulations for the method of operation
2
007002_k_en_--
11 | 54