8
HINTS ON THE USE OF THE HOTPLATE
Utensils should always be placed centrally on the pan supports and over the burners.
Flames which extend beyond the bottom of utensils are wasteful and can damage or
overheat handles. Large diameter utensils (greater than 200mm in diameter) must not be
allowed to protrude beyond the perimeter of the hotplate, as this could cause overheating
or damage to the adjacent bench.
Do not place anything, e.g. flame tamer, asbestos mat, between
pan and pan support as serious damage to the appliances may
result.
Do not remove the pan support and enclose the burner with a
wok stand as this will concentrate the flame and deflect the heat
onto the hotplate.
Do not use large pots or heavy weights which can bend the pan
support or deflect the flame onto the hotplate.
Locate pan centrally over burner so that it is stable and does
not overhang the appliance.
Use only wok support supplied or recommended by the
manufacturer of the appliance.
Additional Installation Instruction
Connection of LPG or TG rubber tube
-
It must be used approved rubber tube bearing EMSD Approval marking (such as
“
機電
工程署批准
EMSD Approval GTXXXX”) and fuse cock for piped gas supply or cylinder
regulator for LPG cylinders for connection.
Connection of stainless steel flexible hose BSP MALE
-
It must be used approved stainless steel flexible hole BSP MALE bearing EMSD
Approval marking (such as
“
機 電 工 程 署 批 准
EMSD Approval GTXXXX”) and
approved fuse cock or gas cock for connection.
HKTG connection
-
Governor: Beckley TG2355-00 should be installed.