5
4.
Install the hotplate in the cut-out (See diagram B).
5.
The gas connection to the regulator is 1/2” BSP. The regulator should be held by a
spanner on the flats provided when making the joins. Turn the gas on and check for
leaks using a soap solution and brush around all joints and connections.
Pressure test point:
-
This is provided in the gas regulator.
-
Remove the screw, connect the hose from the pressure gauge.
-
Turn on the gas to the large burner and manually light the burner.
-
The pressure is shown on the data plate.
-
To increase the pressure, loosen locking nut and turn clockwise.
-
Disconnect gauge and replace test point screw.
6.
Test the appliance:
-
Depress the control knob and turn to full flame setting.
-
The burner will ignite. Adjust control knob to desired setting. Normally, no
adjustment should be necessary.
-
If any problems occur, refer to the servicing instructions or fault isolation chart.
7.
Instruct the user to keep the users instructions manual.
If any of the above procedures do not produce satisfactory results, the
agent’s service department should be consulted for more specialized assistance.
8.
The cooktop is fitted with the flame failure device that cuts off the gas supply when
burner flame extinguishes suddenly or abnormally in order to avoid the gas leakage.
9.
Room Ventilation - This cooktop must be installed in a room that has permanent
ventilation to effect the correct operation of the appliances and also to provide
adequate ventilation. This airflow must exceed 20m³ via permanent vented openings
in the walls of the room and these must have a section of 100cm² minimum. They
must be constructed in a manner so as to avoid any possible blockages. The airflow
can also be drawn indirectly from an adjacent room provided it complies with any
local regulations to vent any fumes outdoors.
WARNING:
-
Do not spray aerosols in the vicinity of this hotplate while it is in operation.
-
Some propellant gases can break down when heated and produce corrosive vapours
which will attack some materials.
-
Articles which are made of flammable materials should not be stored in drawers or
cupboards immediately below this hotplate.
-
The silicone rubber gasket should not be removed under any circumstances. In the
event that any protective rubber gasket is dropped off or damaged, the consumer
should cease forthwith the use of the unit until it is duly rectified.
-
Do not store articles within 50mm of the bottom of the hotplate casing.
-
Do not touch spark igniter while lighting the burner.
-
When the appliance is installed in a marine craft or in caravans, it shall not be used as
a space heater.
