14
Care and cleaning
The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition
Hob
Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
■
Abrasive products
■
heavy-duty cleaners, like oven sprays and stain removers
■
Pads that may scratch
■
High-pressure or steam cleaners
Glass scraper
Remove dried-on food remains using a glass scraper.
1.
Release the scraper safety catch
2.
Use the blade to clean the hob surface
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
Risk of injury!!
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.
Hob frame
In order to avoid damage to the hob frame, follow the
indications below:
■
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
Fixing malfunctions
Malfunctions are generally caused by minor faults. Before
contacting the Technical Assistance Service, make sure you
have read the following recommendations and warnings.
Indicator
Malfunction
Measure
none
The electric power supply has been
interrupted.
Use other electrical appliances to check if there has been a power
cut.
The appliance has not been correctly
connected following the connection
diagram.
Make sure that the appliance has been connected correctly.
Electronic system malfunction.
If in the above checks, the malfunction is not resolved, contact the
Technical Assistance Service.
“
flashing
The control panel is wet or an object is
resting on it.
Dry the control panel area or remove the object.
Ҥ
+ number /
š
+ number /
¡
+ number
Electronic system malfunction.
Disconnect the hob from the mains. Wait 30 seconds or so, then
connect it again.*
”‹
/
”Š
There is an internal error in the system.
Disconnect the hob from the mains. Wait 30 seconds or so, then
connect it again.*
”ƒ
The electronic system has overheated and
the corresponding hotplate has been
switched off.
Wait until the electronic system has cooled down completely. Then
press any symbol on the hob.*
”…
The electronic system has overheated and
all hotplates have been switched off.
—‚
Supply voltage outside normal operating
limits.
Please contact the local electricity board.
—ƒ
/
—„
The hotplate has overheated and switched
off to protect its working surface.
Wait until the electronic system has cooled down sufficiently before
switching it back on.
* If the warning persists call the Technical Assistance Service.
Do not place hot pans on the control panel.
