Siemens DO05705, Installation & Operating Instruction

Page: 16 / 64

16
en
Wall mounting
Undersink appliances DO05705, DO05755,
DO05755K, DO3170D5, DO3175D5 and
DO05705CH
Align the appliance on the wall and use the three indents ■
(top, left and right on the appliance) to apply markings
(A).
Connect the markings by a pattern of crossed lines with a ■
spirit level (B1 and B2).
Place the installation bracket on top at the point of inter- ■
section of the drawn lines and mark the position for the
holes (C).
Drill the holes and insert wall plugs ( ■
D1).
Attach the installation bracket (notch at top) to the wall ■
using the screws (D2).
Suspend the appliance in the installation bracket ( ■ D3).
Exchanging appliances
When replacing an old Siemens small water heater with ■
this new appliance, the existing drill holes with wall plugs
can be used. Please note that the new appliance is approx.
2 cm higher.
If the new appliance is to be flush at the top like the old ap-
pliance (E1):
Attach the new installation bracket to the wall with the ■
notches at the top.
If the new appliance is to be flush at the bottom like the old
appliance (E2):
Turn the installation bracket around and attach to the wall ■
with the notches at the bottom.
D1
D2
D3
2x 2x
C
B2
B1
3x 3x
A
180°
E2 E1