Siemens DE 1113415, Installation And Operating Instructions Manual

Page: 9 / 52

9
en
VI.
Startup/additional information
The device is compliant to IEC 61000-3-12.
First start-up
Switch on the fuses.
■
Setting the temperature.
■
Starts rinsing: Open the warm water tap and allow water
■
to flow for at least 1 minute (flow-rate at least 6 litres per
minute). Only then (for safety reasons) will the appliance
begin to heat.
Tip: Should the appliance not start because of a reduced
flow-rate, remove the perlator, shower head or similar before
start and repeat the process.
Remove the flow-rate limiter (see Fig. A) with low water
■
pressure.
Explain the operation of the continuous-flow heater to
■
the user.
A
If the continuous-flow heater does not have sufficient
water flow due to low water line pressure in your do-
mestic plumbing system, remove the flow-rate limiter.
Technical data
DE 1113415 DE 1821415
DE 4151821
DE 2427415
DE 4152427
Rated output [kW]
11.0
13.0 18
21 24
27
Rated voltage [V] 400 400 400
Fuse protection [A] 16 / 20 32 40
Minimum conductor cross-section
[mm 2 ] 4 4 6
Warm water flow at rated output
with temperature increase from
12 °C to 38 °C [l/min]
6.0
7.1 9.9
11.6 13.2
13.9
12 °C to 60 °C [l/min]
3.8
3.3 5.4
6.3 7.2
7.6
Start-up flow [l/min] 2.6 2.6 2.6
Start-up flow pressure * [MPa (bar)] 0.025 (0.25) 0.025 (0.25) 0.025 (0.25)
Application area in water
specific electric resistance at 15 °C
[Ωcm] ≥ 1 300 ≥ 1 300 ≥ 1 300
Rated pressure [MPa (bar)] 1.0 (10.0) 1.0 (10.0) 1.0 (10.0)
Maximum permissible supply temperature [°C] 55 55 55
Maximum mains impedance at connection
point
[Ω] ≤ 0.244 ≤ 0.244 ≤ 0.244
* The pressure loss on the mixer must also be added
B
Priority circuit for the combination with electrical
storage heaters:
For operation with a priority circuit, a special load
shedding relay BZ 45L20 (special accessory) is re-
quired. Other existing load shedding relays, with the
exception of electronic load shedding relays, may
malfunction.
C
The control electronics must be coded when operated
with a load shedding relay.
D
Status display on the appliance
LED Appliance status
Off Off
Lights up Ready
Slow flash (1/s) Appliance is heating
Fast flash (4/s) Desired water temperature
is not reached (water flow
too high for appliance
rating).
E
The filter upstream from the check valve in the cold
water supply inlet is clogged.
Remove the filter and either clean it or descale it.
See Figure E 1–3.