Configuration
Alarm
9
43
Siemens AG
A6V10334045
22.12.2011
The settings are similar to those for alarm inputs, with some additional functions:
z
Motion Detection
– Select "ON" to enable the motion detection function.
– Select “Track”, to track the moving object.
– Default setting: “OFF”
External digital inputs 2, 3
External digital inputs 2, 3: All configurations are the same as those made for
external digital input 1, except that input mode B/W is not available.
Motion detection settings
The settings are similar to those for alarm inputs, with some additional functions:
1. Motion Detection
Select "ON" to enable the motion detection function.
Default setting: “OFF”.
2. Area
Click “Set Motion Area”.
An image screen will pop up.
Select the target area by dragging the mouse.
3. Sensitivity
Select the desired sensitivity.
High: Even small changes in brightness or motion are detected.
Mid: Intermediate between High and Low.
Low: Only large changes in brightness or motion are detected.
4. Event
Select an event.
Pre-recorded voice files with the extension .wav that have been uploaded to
the SD memory card can be selected as alarm messages. Up to 10 audio
sources can be selected .
Alarm output
1. Alarm mode:
The alarm output can be activated when any of the following events occurs:
– B/W: when the image changes to monochrome.
– Event: When alarm input 1, alarm input 2 or alarm input 3 or motion is
triggered, the alarm output will reflect this immediately as well.
2. Output hold time:
Set a time to hold the alarm output. You can select 0, 5, 10, 15, or 30 seconds.
This function is used when a siren, buzzer or emergency light is connected.