Siemens Climatix POL822, Instruction

Page: 4 / 12

4 / 12
Siemens room unit QAA822 Building Technologies
Function description
Switch the air conditioning unit on or off by pressing the button
OFF/ON .
When the air conditioning unit is switched on, the unit is in
condition before last switching off (
Time Schedule, Economy or
Comfort ). This condition is indicated by combination of icons 6, 7
and 8.
After switching off the air conditioning unit, the unit is either turned
off or it changes over into complementary mode of room frost
protection. This status is indicated by icon 5. In the default setting
of the complementary frost protection mode, the air conditioning
unit is turned off. Only if the room temperature falls below 5°C, the
air conditioning unit is switched on until the room temperature
higher than 5°C is reached. If the room temperature sensor is not
used, it can be substituted by a temperature sensor of the supplied
or exhausted air. The substitution is performed in configuration
parameters
*)
.
After switching on the air conditioning unit by the
OFF/ON button
and by pressing the button Mode the air conditioning unit switches
between the modes Time schedule, Economy and Comfort in
cycles . If no time schedule is set, the air conditioning unit switches
only between the modes Economy and Comfort . The currently
selected mode is indicated on the display by the combination of the
relevant icons 6, 7 and 8.
In the mode
Economy the air conditioning unit is heating or cooling
so that the temperature required for this Economy mode is
reached. This mode is indicated on the display by the icon 7. The
default setting for this mode is 18°C.
The current temperature can be changed temporarily by the
Plus
or Minus buttons. The temperature setting can be changed by the
Parameters button.
The fan speed is preset in the configuration parameters of this
mode
*)
. The speed can be increased by the button Fans in six
steps up to the speed corresponding to the Comfort mode. This
setting is possible only if the configuration parameters are adjusted
for fan button control
*)
.
In the mode
Comfort the air conditioning unit is heating or cooling
so that the temperature required for this Comfort mode is reached.
This mode is indicated on the display by the icon 8. The default
setting for this mode is 22C.
The current temperature can be changed temporarily by the
Plus
or Minus buttons. The temperature setting can be changed by the
Parameters button.
The fan speed is preset in the configuration parameters of this
mode
*)
. The speed can be reduced by the button Fans in six steps
down to the speed corresponding to the Economy mode. This
setting is possible only if the configuration parameters are adjusted
for fan button control
*)
.
Starting the air conditioning unit
Operating mode selection
Operating mode
Economy
Operating mode Comfort