www.siemens.com/buildingtechnologies
Operation (short)
FC120
Fire control panel (NL)
Document ID: A6V10393200_a_en_--
ALARM Procedure
no Alarm Verification Concept (AVC)
Action / Condition
Press
on the PMI.
(Password required)
Look at the LED indicator
'On: Fire brigade called'
'Off: Call fire brigade!'
(
Remote transmission is switched off / not available or
defective)
Read fire location on display.
Go to fire location.
Press
to reset the panel.
(Password required)
Press
twice.
Press
twice.
1.
2.
3.
4.
R
5.
6.
2.
4.
Go to the fire location.
Fire alarm
Zone 1 1/1
Meeting room 1
3.
ALARM-Procedure
Switching off zones
Switching on zones
Procedure in case of Fault
Edition: 2013-07-24
– suggested possible procedure – subject to local requirements
Consequence / Status
Buzzer is turned off, alarm is acknowledged.
Remote transmission is switched off / not available or
ALARM is transmitted to fire brigade.
Fire brigade must be called by phone!
–
No automatic transmission to fire brigade
–
Dial the following no
.:
Information on the cause of ALARM; if required, initiate required
emergency measures and damage limitation.
Fire detection system is in normal condition unless another
event occurs. It may be necessary to vent the room before
resetting is possible. Elements that cannot be reset can be
switched off temporarily.
Stop the evacuation.
Start the evacuation.
1.
Go to the fire location.
Fire alarm
R
Siemens Switzerland Ltd
Industry Sector
Building Technologies Division
International Headquarters
Gubelstrasse 22
CH-6301 Zug
Page 1
Page 2
Page 3
Page 4
1 / 4
subject to local requirements
Buzzer is turned off, alarm is acknowledged.
ALARM is transmitted to fire brigade.
be called by phone!
No automatic transmission to fire brigade
Information on the cause of ALARM; if required, initiate required
emergency measures and damage limitation.
Fire detection system is in normal condition unless another
event occurs. It may be necessary to vent the room before
resetting is possible. Elements that cannot be reset can be
5.
6.
