SIEMENS 5890 DSL Router
User’s Guide
Chapter 3 Easy Setup
Select Protocol
SIEMENS
26
RAW IP
If you selected
RAWIP
from the Wan Interface page, the RAWIP Networking page is displayed when you click
Next
.
To configure RAWIP Networking:
1. Select one or more of the following RAWIP Networking options:
•
Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select
Only bridge PPPoE traffic
.
If selected, only PPPoE traffic is bridged; all other traffic is
stopped
•
IP Routing Enabled:
Routes all IP packets for remote hosts to the WAN. If IP Routing is enabled, you must specify how to
obtain an IP address and subnet mask. This can be one of the following:
– Obtain configuration automatically from Wan using DHCP
to have an IP address assigned
automatically using DHCP.
– Configure IP Routing manually
to assign IP addresses manually. If you select this option, you must
specify an
IP Address
and
Subnet Mask
in the appropriate fields.
2. If you enabled IP routing, optionally select one or more of the following:
•
NAT Enabled:
Network Address Translation (NAT) allows multiple workstations on your LAN to share a single, public
IP address. All outgoing traffic appears to originate from the router’s IP address.
•
Block Net BIOS Traffic:
NetBIOS is a PC networking protocol that can keep network connections open inadvertently. To avoid
excess connection charges, such traffic should be blocked on any metered network service.
If your Network Service Provider has not provided specifics for use in making these settings, select
Obtain
configuration automatically from Wan using DHCP
and
NAT Enabled.
3. Click
Next
. This displays the
Dynamic Host Configuration Protocol
page.
