System
unit
1
2
i
Fasten the cover plate (1) with the two screws (2) to the underside of the
new floppy disk drive.
Attach the contact collar (2) to the new drive.
If you cannot attach the old contact collar, inform our customer service.
If required, set up the new floppy disk drive as the first drive (drive A:).
1
2
Slide the new floppy disk drive into the carrier.
Fasten the floppy disk drive with the four screws you removed earlier.
Replace the drive carrier in the system unit and refit the top cover as described
in "Assembling the system unit".
If the new floppy disk drive is not the same as the one that was removed,
i
you must change the entry for floppy disk drive A: in the setup menu.
A26361-K381-Z129-3-7619
23
System unit
Changing the hard disk drive
Remove the top cover and the drive carrier as described in "Opening the system
unit".
Loosen the two screws of the floppy disk drive (approx. four turns).
2
1
Remove the four screws that secure the hard disk drive to the carrier.
Slide the hard disk drive out of the drive carrier.
If required, set up the new hard disk drive as drive C: (see documentation
supplied with the hard disk drive).
24
A26361-K381-Z129-3-7619
