Add-on modules
3
4
5
1
2
6
7
1 = Location lithium battery
5 = Socket for processor
2 = Location bank 1 for main memory
6 = Socket for video memory
3 = Location bank 0 for main memory
7 = Connector for external monitor controller
4 = Connector for external loudspeaker
(VESA VGA pass through)
Upgrading main memory
Two locations (Bank 0 and Bank 1) are available on the system board for
connecting memory modules.
The board supports a maximum of 32 Mbytes. You may use memory modules of 4,
8, 16 or 32 Mbytes. For the memory configuration we recommend to use memory
modules of the same capacity.
If you want to install or remove memory modules, you must remove the drive
carrier (see Technical Manual of the PC).
!
You may only use fast memory modules (access time = 70ns or less).
A26361-D824-Z120-5-7619
23
Add-on modules
Installing memory modules
If you want to install several memory modules, plug the first memory module into
the bank 0.
1
2
Insert the memory module at angle into the appropriate location (1).
Ensure that the key notch and the two holes are correctly aligned with the
retaining pins.
Tilt the module down until it snaps into place (2).
Removing a memory module
1
1
3
2
Carefully push the retaining clips at each end of the module outwards (1).
Tilt the module upwards (2) and pull it at an angle out of the location (3).
24
A26361-D824-Z120-5-7619
