Assembly and operating instructions
DRIVE axxent DK
03.2021
27
Problem
Solution
The window cannot be opened
automatically.
Perform emergency release:
1. push card between the frame and window sash in accordance with the figure
2. slide card forwards (in the direction of handle) and at the same time
3. move the handle into the locking position and
4. open the handle
1.
3.
4.
2.
Position LED
Problem
Possible cause
Solution
DRIVE axxent DK cannot be opened
manually
Decoupling does not function
Perform emergency release:
check that the mushroom bolt is properly
seated
check the airgap
check milling dimensions if necessary
(timber windows)
readjust the DRIVE axxent DK if necessary
(see page 26)
Auto-Lock does not work /
The window does not move into the
turning position
The window was operated
manually beforehand
Connect the DRIVE axxent DK
(see page 19)
The magnets are seated in the
incorrect position
Check the position of the magnets and
correct if necessary (see page 15)
Incorrect DIP switch position
DIP switch 1, 3 and 4 ON
DIP switch 2 OFF
DRIVE axxent DK shows no reaction
when button is pressed or radio
remote control
No power supply
Check power supply
wiring wrong/defective or cable
defective
check the wiring (see page 12)
Power supply wrong/defective
Measure the supply voltage
Target values:
input
230 V AC; 50/60 Hz; 170 mA
ouput
24 V DC; 0.75 A; 18 W
Battery of radio remote control is flat Replace battery
