Siebeck GmbH
Translation of the original operating manual
0411 FRT-A-MKIIIbed
Page 41
MAINTENANCE INSTRUCTIONS
Assembly group
M6 Knotting
aggregate
M40 Ring
Interval
for single-shift
operation
daily after
cleaning
weekly
daily
weekly
monthly
Measure / procedure
Spray all around with water-repellent
spraying oil, apart from
the twine button area
Pay particular attention to covered
pressure bearing on the front of the
main shaft
Grease all sliding and rotating parts
Repeat the above procedure after
several turns of the aggregate (jog
mode)
Lubricate the lubricating nipples (1x
on the draw slide head, 1x on the
pivot pin for the toothed segment)
with a suitable grease gun
Check the knife for wear. Flip or
replace it as necessary.
Check that the cam rollers move
freely Check the tension and
pressure springs for breakages
Check the clamping surfaces on the
twine button for damage
Check the aggregate's zero position
Pages 36-37
Check the stripper setting
Page 35
Check the knotter housing play and
adjust guide piece as necessary
Check that the drive chain is
sufficiently tensioned and re-tension
as necessary
Oil the twine rollers and take-up
lever bearing unit and check that
they move freely Check the
smoothness of the tying arm insert
and clean it
Check the V-belt tension and re-
tension as necessary
Check the ring for play
Adjust the ring rollers as necessary
