16
5693
11
2020
-
SE60/185 s2
MG_0029
1
2
3
4
IMPORTANT
Do not position support
on the motor cap.
FASTEN
(18 Nm)
(13.28 lb/ft)
Motor support
Motor
Cap
> 30°
Drive Pin
Gasket
Turn gear leg shaft so
the motor coupling
fits into the slots.
Coupling
MG_0028
Anode holding screw
Apply Loctite 243 or similar
Anode
Lock nut
Washer
Propeller
Drive pin
Anti-fouling
Propeller Installation
EN
MC_0018
!
Please refer to the graphic for special considerations relating to your model
!
1. Centre the drive pin and Insert the propeller onto the shaft spine. Rotate the propeller until the drive pin aligns with the internal slot in the propeller.
2. Insert the washer to the end of the shaft spline. Tighten with the propeller lock-nut.
3. Insert the anode to the end of the propeller and tighten the anode holding screw. Apply a thread glue (Loctite 243 or similar) to ensure that the
anode holding screw does not unscrew itself from during the rotation of the propeller.
4. Apply anti-fouling to the gear leg and propeller. Do not apply anti-fouling to any rubber elements of the gear leg or anodes.
