Side-Power SE-170 Installation Manual Download Page 25

Page: 25 / 28

6367

2020

SE170

1. The equipment manufactured by Sleipner Motor AS (The “Warrantor”) is warranted to be free from defects in workmanship and materials under normal

use and service.

This Warranty is in eﬀ ect for of two years (Leisure Use) or one year (Commercial use) from the date of purchase by the user. Proof of purchase must be

included, to establish that it is inside the warranty period.

3. This Warranty is transferable and covers the product for the specifi ed time period.

4. In case any part of the equipment proves to be defective, other than those parts excluded in paragraph 5 below, the owner should do the following:

(a) Prepare a detailed written statement of the nature and circumstances of the defect, to the best of the Owner’s knowledge, including the date of

purchase, the place of purchase, the name and address of the installer, and the Purchaser’s name, address and telephone number;

(b) The Owner should return the defective part or unit along with the statement referenced in the preceding paragraph to the warrantor,

Sleipner Motor AS or an authorized Service Centre, postage/shipping prepaid and at the expense of the Purchaser;

(c) If upon the Warrantor’s or Authorized Service Centre’s examination, the defect is determined to result from defective material or workmanship, the

equipment will be repaired or replaced at the Warrantor’s option without charge, and returned to the Purchaser at the Warrantor’s expense;

(d) no refund of the purchase price will be granted to the Purchaser, unless the Warrantor is unable to remedy the defect after having a reasonable

number of opportunities to do so. Prior to refund of the purchase price, Purchaser must submit a statement in writing from a professional boating

equipment supplier that the installation instructions of the Installation and Operation Manual have been complied with and that the defect remains;

(e) warranty service shall be performed only by the Warrantor, or an authorized Service Centre, and any attempt to remedy the defect by anyone else

shall render this warranty void.

5. There shall be no warranty for defects or damages caused by faulty installation or hook-up, abuse or misuse of the equipment including exposure to

excessive heat, salt or fresh water spray, or water immersion except for equipment specifi cally designed as waterproof.

6. No other express warranty is hereby given and there are no warranties which extend beyond those described in section 4 above. This Warranty is

expressly in lieu of any other expressed or implied warranties, including any implied warranty of merchantability, fi tness for the ordinary purposes for

which such goods are used, or fi tness for a particular purpose, and any other obligations on the part of the Warrantor or its employees and

representatives.

7. There shall be no responsibility or liability whatsoever on the part of the Warrantor or its employees and representatives for injury to any person or

persons, or damage to property, loss of income or profi t, or any other consequential or resulting damage or cost which may be claimed to have been

incurred through the use or sale of the equipment, including any possible failure or malfunction of the equipment, or part thereof.

8. The Warrantor assumes no liability for incidental or consequential damages of any kind including damages arising from collision with other vessels

or objects.

9. This warranty gives you specifi c legal rights, and you may also have other rights which vary from country to country.

For the most up to date documentation, we advise you to

visit our website

www.side-power.com

for the spare parts

list.

For additional supporting documentation, we advise you

to visit our website

www.side-power.com

for the spare

parts list.

Spare Parts

Product Templates and Additional Resources

Warranty statement

MC_0024

MC_0033

Pre-delivery Checklist

�.......... The bolts holding the gear house and motor bracket together are tightened correctly.

�.......... The bolts holding the motor to its bracket are tightened correctly.

�.......... All electrical connections are clean, dry and tight, and the correct cable, fuse and main

switch size.

�.......... Check that there is no electrical connection between the electro motor body and positive

terminal on the motor, and between the electro motor body and the negative (A1) terminal

on the motor with an ohm meter.

�.......... Anti-fouling has been applied to the gear house and propeller but NOT anodes, sealing/

rubber fi ttings or propeller shafts.

�.......... Propeller is fastened correctly to the shaft.

�.......... Propeller turns freely in tunnel.

�.......... The anode and/ or holding screw is tightened well with thread glue.

�.......... Check the boat for potential water leakage around installation areas.

�.......... Correct drive direction as per control panel.

�.......... User Manual is supplied to the owner.

The thruster has been installed as per the instructions in this manual and all points in checklist above have been controlled.

Signed: .........................................................................................

Date: .............................................................................................

Thruster type: ................................................................................................................................................................................................

Serial number:...............................................................................................................................................................................................

Date of delivery:.............................................................................................................................................................................................

Correct drive direction as per control panel: ..................................................................................................................................................

The compartment for the thruster has been isolated from general bilge water and has no obvious or suspected risks for fl ooding:

......................................................................................................................................................................................................................

Other comments by installer: ........................................................................................................................................................................