7
PJC-222
1.0.6 - 2012
NB!
NB!
SETUP
(cont.)
OK:
Saves the calibration setup and returns to “SETUP”-
menu
Cancel: Returns to “SETUP”-menu without saving changes
Any changes made will be relayed to all other installed panels
(Firmware 1.007 or newer)
RADIO REMOTE SETUP
Adjusts the amount of thrust which the ON/OFF remote control
will run at. Use joysticks to adjust applied thrust
OK:
Saves changes and returns to “SETUP”-menu
Cancel: Returns to “SETUP”-menu without saving changes
Any changes made will be relayed to 8730 INTERFACE units with
Firmware 1.203 or newer
SYSTEM DEVICES
View all devices connected to S-Link and manually change setup
values.
Slide between devices with the joystick to see device information
as location, thruster direction, retract type, firmware version and
serial number.
Edit: Change location to BOW, STERN, BOW-PORT or STERN-
PORT, thruster direction to Normal or Inverted or retract
type. For Automatic main switch 1 8977 and interface
8730, you can only change location. Use joystick to alter
values.
Location:
Can change selected device location between BOW ,
STERN, BOW-PORT or STERN-PORT. For PPC800 or
SR61242 only. (use BOW-PORT on second bow thruster
and STERN-PORT on second stern thruster)
Direction:
Can change thruster direction to Normal or Inverted.
Change this value if the thruster is running in the wrong
direction. For PPC800 or SR61242 only.
Retract:
Setup retract types. For PPC800 or SR61242 only.
Normal:
stand alone, use this for PPC800 without any
retract or SR61242 (SR80/100) without
PPC800 or SR150000 (SR130/170/210)
without PPC800.
Type 1:
Retract SR61242 (SR80/100) with PPC800,
both devices needs to be set to Type 1.
Type 2:
Retract SR150000(SR130/170/210) with
PPC800, both devices needs to be set to
Type 2
WHEN INSTALLING A RETRACT THRUSTER WITH
SPEED CONTROL (PPC800), DO NOT TRY TO RUN
THE THRUSTER UNTIL YOU HAVE COMPLETED THE
ENTIRE SETUP PROCEDURE CORRECTLY!
This is to prevent damage to the thruster caused by run-
ning the thruster while the retract mechanism is not fully
opened.
OK
:
Saves changes and quit editing.
Select
: Switch between Location, Retract and Retract set-
tings.
Cancel
: Cancel operation without saving changes.
Cancel: Returns to “SETUP” –menu.
