Installation & User Manual, Radio Remote RC12E
Page 7
Programming additional receivers
The original transmitter and receiver have the same factory preset code so that no programming
is necessary. When additional transmitters are to be used, the receiver must be programmed
again for all transmitters.
1. Deactivate the receiver and all transmitters (press “OFF” on all transmitters).
Turn off the main power switch for the windlass(es).
2. Turn on the power to the receiver.
3. Push the Pair Button on the receiver with a plastic stick (as shown above).The LED below the
button will start to blink.
4. The receiver and transmitter are programmed by pressing both “ON” buttons on the transmit-
ter. Within 5 seconds the LED will change from blinking to continous light when the program-
ming signal is received. The transmitter is then ready to use.
5. Additional transmitters must be programmed according to step 3-4 when the receiver is in
“Program mode”. You can pair up to 4 transmitters.
6. To clear all transmitters, hold Pair Button until LED blinks slow, continue to hold button pressed
until LED blinks quick indictaing that a reset process is started. When LED is turned off, the
reset process is completed, and the Pair button can be released. The LED will come on when
the receiver has completed the reset process and is ready to be paired (Step 3-4)
Push the Pair Button with a plastic stick
