Installation & User Manual, Radio Remote RC12E
Page 3
Technical specifications
• You should always install at least one original windlass panel.
•
Use the remote only for shorter periods of time to preserve transmitter battery life. Use the
main control panel for longer runs of the windlass.
•
This manual is intended to support educated / experienced staff and is therefore not sufficient
in all details for the correct installation.
•
When installed in boats approved or classified according to international or special national
rules, the installer is responsible for following the demands in accordance with these regula-
tions / classification rules. The instructions in this guide can not be guaranteed to comply with
all different regulations / classification rules.
•
The transmitter and the receiver have the same factory preset code so no programming is nec-
essary. When additional transmitters are to be used, the receiver must be programmed again
for all transmitters (please see programming section on page 7).
Transmitter
Receiver
Model RCT-12E
RCR-1E
Power feed
1 x 3V battery (type: CR2032)
From windlass supply
Frequency (MHz)
433,2
433,2
Operation temp.
-10°C / +55°C
-15°C / +55°C
HxWxD (mm)
95x48x25
89x68x33
Weight (g)
60
135
Voltage:
8-30V
Load, max
4A
Operating range: 15m under normal operating conditions
Important precautions
