11
8019969/V1-0/2016-06 | SICK
A D D E N D U M T O O P E R A T I N G I N S T R U C T I O N S | S710 E
Subject to change without notice
ENGLISH
2
2
ENGLISH
2.1
About this document
2.2
Preparations
These short instructions describe settings you can make to use the additional features of
the S710 E.
You can make these settings:
●
After the device has been integrated in the measuring system
or
●
Before the device has been integrated in the measuring system.
Note
: Check the setting of the power voltage is correct (see “Operating Instructions
S700”).
Use the supplied power cable to connect the device to a suitable power supply and
switch it on using the main power switch on the rear of the device.
You can make the following settings after booting the device:
●
Change the physical unit in which the measured values are shown between mg/m³ and
ppm.
●
Adapt the preset measuring range according to your application.
WARNING:
▸
This document is only valid in combination with the S700 Operating Instructions.
▸
You must have read and understood the S700 Operating Instructions (see delivered
CD-ROM).