Chapter
2
Mounting instructions
Mounting kit 2
8
• SICK AG • Industrial Safety Systems • Deutschland • Al rights reserved
8 011 148/
14
-04-05
Mounting
2.3.2
Premounting horizontal adjusting arms on the left/right
Remove the screws (6).
Place the cross adapter (4) on the adjusting arm (1) so that the hole for the clamping
lever (5) shows to the left at the left-hand adjusting arm and to the right at the right-hand
adjusting arm.
Mount the cross adapter with spring washers and screws in the sliding nuts (2).
Tighten the screws hand-tight so that the cross adapter can still be moved later.
Put the cover (3) on the adjusting arm.
2.3.3
Mounting horizontal adjusting arms at press crossheads
Drilling holes in press crossheads
According to the dimensional drawing, drill holes (10.2 mm in diameter and at least
25 mm in depth) from behind into the press crosshead (1).
Cut a thread M12, min. 20 mm deep.
Blow out the thread hole clean.
Fig. 4: Premounting horizontal
adjusting arms
Fig. 5: Mounting horizontal
adjusting arms at press
crossheads (rear view of
press crossheads)
