Operating Instructions
Chapter
10
ICR890
Appendix
8011325/0000/2006-10-24
©
SICK AG · Division Auto Ident · Germany · All rights reserved
111
10
Appendix
10.1
Appendix overview
The appendix contains the following additional information:
•
Configuring the ICR890 System with command strings
•
Help table for calculating code length of a bar code
•
Ordering information
•
Supplementary documentation (overview)
•
Glossary
•
Image of EC Declaration of Conformity
•
Decodeable 1-D codes/2-D codes
10.2
Configuring the ICR890 System with command strings
As an alternative to the SOPAS-ET Configuration Software, the ICR890 System can also be
configured and operated with command strings via all the data interfaces. Each command
string can be displayed via the SOPAS-ET Configuration Software.
¾
To request a command string in the SOPAS-ET Configuration Software, use the right
mouse button to click on a parameter.
Note
Both the command strings and the SOPAS-ET Configuration Software are based on
command language which directly accesses the command interpreter of the ICR890
System. This command language must be used with care as the ICR890 System executes
sent commands immediately. Parameter values altered via commands are at first only
active in the current parameter set in the working memory (RAM) of the ICR890 System. To
save in the permanent memory, the altered parameter set must be copied into the EEPROM
using a special command, this ensures that the alterations are not lost when the power
supply is switched off.
