OPERATING INSTRUCTIONS | DOSIC
®
8020955/11HD / 2018-12-12| SICK AG
Subject to change without notice
9
2
SAFETY INFORMATION
2.5
Requirements for skilled persons and operating personnel
WARNING
Risk of injury due to insufficient training.
Improper handling of the sensor may result in considerable personal injury and material
damage.
• All work must only ever be carried out by the stipulated persons.
The operating instructions state the following qualification requirements for the various
areas of work:
•
Instructed personnel
have been briefed by the operating entity about the tasks
assigned to them and about potential dangers arising from improper action.
•
Skilled personnel
have the specialist training, skills, and experience, as well as
knowledge of the relevant regulations, to be able to perform tasks assigned to
them and to detect and avoid any potential dangers independently.
•
Electricians
have the specialist training, skills, and experience, as well as knowl
-
edge of the relevant standards and provisions to be able to carry out work on
electrical systems and to detect and avoid any potential dangers independently.
In Germany, electricians must meet the specifications of the BGV A3 Work Safety
Regulations (e.g., Master Electrician). Other relevant regulations applicable in other
countries must be observed.
The following qualifications are required for various activities:
Activities
Qualification
Mounting, maintenance
• Basic practical technical training
• Knowledge of the current safety regulations in the workplace
Electrical installation, de
-
vice replacement
• Practical electrical training
• Knowledge of current electrical safety regulations
• Knowledge of device control and operation in the specific appli
-
cation concerned (e.g., conveying line)
Commissioning,
configuration
• Basic knowledge of the control system used
• Basic knowledge of the design and setup of the described
connections and interfaces
• Basic knowledge of data transmission
Operation of the device for
the specific application
• Knowledge of device control and operation in the specific appli
-
cation concerned (e.g., CIP/SIP system)
• Knowledge of the software and hardware environment for the
specific application concerned (e.g., CIP/SIP system)
2.6
Operational safety and specific hazards
Please observe the safety notes and the warnings listed here and in other chapters of
these operating instructions to reduce the possibility of risks to health and avoid dan-
gerous situations.