8017035/ZMO9/2017-06-08 • © SICK AG • Subject to change without notice.
55
PRO2-Navigator Setup Software
6.4
Setup Procedure
6.4.1
Connecting to the Sensor Head
When the sensor head and computer are connected, click “Connect” to
connect to the sensor head and automatically update the measured value.
If the connection fails, the message “Failed to connect to Profiler 2 unit.”
will be displayed. When you close the message, the common setup screen
will be displayed.
Select the port that is connected to the sensor head and the communica-
tion speed, and then click “Connect” again.
After you have established a connection between the sensor head and
the computer, configure the measurement settings with the sensor head.
Click “Settings” to switch to the “Input/Trigger” screen. Click the tabs on
the left side of the screen in the order shown to set each item.
Reference: For details on the measurement settings, see the following sections.
•
• 6.4.5 Area Settings
• 6.4.6 Calculation Settings
• 6.4.7 Output Settings
