GCxxxLink
–User and installation guide
3
7) Close the access cover by pressing in the vicinity of
the latches (fig.7).
It is now possible supplying auxiliary circuits and
MAINS/GENERATOR voltages
INFORMATION
: Leave the swith on BATTERY OFF
when the device does not have the main power
supply (JD) and should not be used for a long time:
this allows you not to unnecessarily discharge the
internal battery.
WARNING
: In the internal battery operating state
and in the absence of the main power supply (JD),
the device is not able to manage the operation of
the genset. It must be left in OFF/RESET mode.
Controller LINK have two LEDs indicating modem's
operating states (Fig.6).
LED light work’s behaviour as below:
•
LED1 (Net)
: yellow LED flashes with different
modalities according to the connection status with the
mobile network.
64ms ON and 800ms OFF:
modem not registered to
the mobile network.
64ms ON and 3000ms OFF
: modem registered to the
mobile network.
64ms ON and 300ms OFF:
modem is exchanging
data on the mobile network.
•
LED2 (Status):
green LED indicates whether the
module is on and ready to use.
Both OFF
: the modem is off or in Power Save Mode.
The
GC315
Link
e
GC400
Link
controllers can be supplied optionally with a Lithium Ion internal rechargeable
battery, which is able to ensure only its data transmission and localization for some hours in case of lack of
the main supply. The recharge happens automatically by supplying the device; the full charge requires
approximately 12 hours, after which the battery is in permanent buffer charge.
The device operation time depends on several factors, such as the environment temperature, the data sending
frequency and the mobile network signal intensity. The duration of the battery can be highly increase by
activating one of the two types of energy saving.The battery is activated/deactivated through the switch
D
(fig.6).. The internal battery can be recharged only when the device temperature is between 0°C and +50°C.
If the battery deactivates the recharge cycle, the monitoring is carried out anyway. Leave the swith on
BATTERY OFF
when the device does not have the main power supply and should not be used for a long time:
this allows you not to unnecessarily discharge the internal battery.
The
GC315
Link
e
GC400
Link
controllers can send alerts directly to a mobile phone via SMS (mobile originated
SMS); to do so, the device can need to be programmed to send SMS to a specific phone.
For the SMS you can receive and for the commands you can send see the document
EAAS0341xx Serial
Comunication and SMS protocol.
