14
User’s Manual
4
Each programming page, used for input/modify a variable value, contains a 3-digit code that
is useful to identify the variable across different language text.
Each menu or page shows, on top right of the display, a number pair. The first one is used to
identify the current page or the selected menu; the second one shows how many items are in
the present menu/list.
Please refer to SICES document EAAM008800 (or following versions) for programming and
default values.
Program access can be restricted by means a password. There are 3 different access level
and password:
1. Maker
2. System (installer)
3. User.
First page of
SYSTEM
menu (
000-Access code
) let the user input password, if at least one
of the three passwords is different from 0.
If any password is set to 0, it is not assigned and not required.
As
USER
it is possible to modify only the User Password.
As
INSTALLER
it is possible to modify the User and the System Password.
As
MAKER
it is possible to modify all the three passwords.
Only enabled pages for the access level the operator has gained access to be shown in the
menu, included the password modify pages.
It’s possible that, after password input, menu doesn’t show all the allowed pages. In this case
press EXIT (to go to previous menu) and access again the menu, allowing the board to reload
again the menu.
The keyed access code is kept alive for a time of about 10 minute after the programming
function is ended. After this time, the code should be keyed again, if requested, to gain access
to the same level.
In case of forgotten password, only knowing password of greater level is possible to rescue
the access level. Otherwise and in case of MAKER password the board should be returned to
the factory to reset password level.
Some parameters require text input or modify.
In these cases, pressing ENTER to activate the modify function on the selected variable,
besides the square brackets flashing, it is activated an underline cursor at the first character
string position. Using horizontal scroll keys (left and right arrows), select the character to
modify then use the vertical scroll key (up and down arrows) to scroll allowable values and
select the needed one. Repeat the operation for all the characters that must be modified.
Pressing ENTER, save text and left the function, pressing EXIT the procedure is aborted and
the previous text is restored.
