8
SPECIAL PROCEDURES
TO REACTIVATE THE ROLLING SICE TECH CODE INSERTED AS DEFAULT ON A
BUTTON, PROCEED AS HERE BELOW:
1.
While pressing the button 1 of the WHY EVO, at the same time press 4 times the 2 button.
2.
Release both buttons. Now the WHITE LED “WHY EVO” will emit a short flash every 2 seconds.
3.
Press the button where you want to reactivate the rolling code and retain pressed till the WHITE LED will become BLUE
and then it switches off. At this moment, an extended sound “BEEP” will be emitted to confirm the correct reactivation.
NOTES:
TO reactivate further buttons of WHY EVO, please repeat the operation form the step 1.
TO MAINTAIN THE SAME SERIAL NUMBER ON ALL 4 BUTTONS
1.
While pressing the button 1 of the WHY EVO, at the same time press 4 times the 2 button.
2.
Release both buttons. Now the WHITE LED “WHY EVO” will emit a short flash every 2 seconds.
3.
Place the original remote control to be programmed in front of the “WHY EVO”, at about 5 cm of distance (as shown in
the picture at the page 3).
4.
Press and retain pressed the 1 button of the original remote control and wait for a change of color (BLUE) of “WHY EVO”
WHITE LED that it will switch off and it emit an extended sound “BEEP” to confirm the correct learning code. This step
may take some seconds.
5.
The copy has been happened.
6.
Activate now the correct procedure for the copied model and insert the new remote control on the receiver (see the
compatibility list present in this manual).
6.3
