7
6.3
1.
While pressing the button 1 of the “NEW WHY EVO”, at the same time press 4 times the 2 button.
2.
Release both buttons. Now the WHITE LED of “NEW WHY EVO” will emit a short flash every 2 seconds.
3.
Place the “SOURCE WHY EVO” in front of the “NEW WHY EVO” , at about 5 cm of distance (as in the picture 3 at the page 3).
4.
Press and retain pressed the button to be programmed of the “SOURCE WHY EVO”
NOW IF THE CODE IN THE “SOURCE WHY EVO”
Notes:
• If the WHITE LED flashes only 3 times (of WHITE color) and switches off, the code has not learnt correctly. Please repeat the operation
from the step 1.
• The WHY EVO memory is completely re-writable.
• To duplicate further buttons of WHY EVO, please repeat the operation from the step 1.
WHY EVO WHY EVO
DUPLICATING PROCEDURES
IS A FIXED
OR ROLLING-SIMPLE CODE
5a
wait for a change flash (as a faster flash) of “NEW
WHY EVO” WHITE LED and a change of its color (BLUE)
that confirms the correct learning of code. This operation
may take some seconds.
6a
While the BLUE LED is flashing, press the button of
the “NEW WHY EVO” where you want to program the
code just learnt, and retain pressed until the LED will
switch off and an extended sound “BEEP” is emitted for a
reconfirmation of the correct code learning.
7a
The copy has been happened with success. Now check
on the automation the correct functioning of NEW WHY
EVO remote control pressing directly the button where
the code has been programmed. If it will not work, please
proceed with the insertion on the receiver of the NEW
WHY EVO, through the
function, if it is present,
or through the procedures given by the automation
manufacturer.
IS A ROLLING-COMPLEX CODE
5b
The WHY EVO WHITE LED will emit a short flash every
2 seconds supported by two following sound “BEEP”.
These two alerts inform the user that, to duplicate the
remote control, it is necessary to emit the SEED CODE to
realize the copy.
6b
Transmit now the SEED CODE of the “SOURCE WHY
EVO” pressing at the same time 1 and 2 buttons for 3
seconds till the switch on of WHITE LED. While the LED is
flashing, (within 10 seconds) pressing and retain pressed
the button where you want to program the SEED CODE.
7b
Now the WHITE LED of the “NEW WHY EVO” will
change the flash (more fast) and color (BLUE) to confirm
the correct learning of the code. This step may take some
seconds.
8b
At this moment, press the NEW WHY EVO button when
you want to store the code and retain pressed until the
WHY EVO BLUE LED, switches off and an extended sound
“BEEP” is emitted to confirm the correct learning of the
code.
9b
The copy has been happened with success. Now
check on the automation the correct functioning of NEW
WHY EVO remote control pressing directly the button
where the code has been programmed. If it will not work,
please proceed with the insertion on the receiver of the
NEW WHY EVO, through the
function, if it is present,
or through the procedures given by the automation
manufacturer.
