SiboTech ENB-302MI, User Manual

Page: 8 / 39

www.sibotech.net
- 8 -
Pin Signal Description
S1 TXD+
，
Tranceive Data+, Output
S2 TXD-
，
Tranceive Data-, Output
S3 RXD+
，
Receive Data+, Input
S4 Bi-directional Data+
S5 Bi-directional Data-
S6 RXD-
，
Receive Data-, Input
S7 Bi-directional Data+
S8 Bi-directional Data-
2.4 Configuration Switch
Configuration switches located on the bottom of the gateway, set the mode bit (bit 1) to 0 (Off), and set
function bit (bit 2) to 0 (Off), power (or restart) the device to work.
Mode bit (bit 1) Function bit (bit 2) Description
Off Off
Operation mode, allowing read and write
configuration data
Off On
Operation mode, read and write
configuration data against
On Off or On
Configuration mode, IP address is fixed at
192.168.0.10, this mode can only read and
write
configuration data, can not
communication between EtherNet / IP and
Modbus network
2.5 Installing software
Take the product CD into the computer CD drive, open the CD, install the configuration software GT-123.
You can easily follow the prompts to complete the installation. Then open the configuration software and finish
the configuration of ENB-302MI!
Note: The factory set of ENB-302MI is DHCP, if the network is no DHCP Server, you can set mode bit (bit
1)to 1(On), and restart ENB-302MI, then the fixed IP address of ENB-302MI is 192.168.0.10, mask is
255.255.255.0, gateway address is 192.168.0.1.