Zero-G (Flush)
Installation Instructions
INSTALLERS: PLEASE LEAVE THIS MANUAL WITH THE OWNER.
ZERO-G DISCLAIMER
• Do not use a knife to cut foam/wrapping, you may cut cables.
• Due to the complexity of Zero-G, please scan the QR code to review the installation video before
proceeding:
• A minimum of 12” of drop must be met to ensure no mechanical failures.
• Please use the supplied data cable & wall switch for initial setup before introducing 3rd party
control systems.
• Before operating, please inspect helix & wing cable pulleys didn’t lose tension during transit.
• Please contact SI support at (512) 832-6939 w/ any install related questions prior to installation
or scan the QR code to get more details:
• Leveling the Zero G Case and Wing/Lower Tube Assembly: These pieces MUST be level and
parallel within 1/16th of an inch. Failure to accurately level these two pieces can cause the
screen cables to become unstable and fray over time.
Installation video
for external Zero G
Support page
QR code
Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/
installer will be responsible for all costs associated with failure to comply, including replacement parts, and/
or additional on-site visits needed for repair work.
