7
Each Veil drape includes an RTS installation remote,
regardless
of which control type you selected.
This remote is used to adjust limits and “My” preset and program group controls.
Note: SI only supports using this method. SI technical support and these instructions are only
written for this method.
PROGRAMMING STEPS (must follow in order)
Step 1: Move fabric to fully open position.
Step 2: Attach motor and apply power.
Step 3: Set remote into programming mode by holding the up and down buttons untill the motor jogs.
Step 4: Briefly press up or down and the motor will
automatically
find its limits.
Step 5: Once the motor stops moving, press the up or down button to send the motor to one of its limits.
Step 6: If the rotation direction is correct with the button, move to the next step. If the rotation direction
is incorrect, hold the “My” button untill the motor jogs once.
Step7: Finally briefly press the programming button at the back of the remote, the motor will jog, this will
permanently save the limits.
Warning: Do not attempt to use any installation remote until all the drapes are installed.
Warning: Only 1 motor should be powered on and initially programmed to keep from accidentally
pairing several motors to a single remote control.
Setting Limits
SETTING LIMITS
Summary of Contents for Veil Tracks
Page 2: ......
