Si-tex NAVSTAR 10, Operation Manual

Page: 22 / 126

- 21 -
Installation of the Transducer
A careful installation will assure maximum performance from your new NAVSTAR
10/12 series.
Display Unit Location
Select a location for your Display unit that provides easy viewing from all likely operator’s positions.
The display unit is designed to be mounted on either a console or from an overhead surface. The
Display unit is also designed for flush mounting using six threaded holes on the rear panel. Locate the
display in an area with protection from the elements and avoid direct sunlight on the viewing window.
Also, consider access to the rear panel of the unit for connecting power and cables to the various
remote sensors. The mounting surface must be flat and solid to support the unit and prevent vibration.
There should be access to the inside of the surface to permit through bolt fastening for the mounting
bracket.
Display Unit Installation
Temporarily install the mounting bracket on the NAVSTAR 10/12 series display unit and place the unit
at the selected location.
CAUTION
The Display unit is unstable when the mounting bracket is not secured. Hold the unit in place
at all times.
Check the suitability of the location and make any adjustments. When all is satisfactory, use the holes
in the mounting bracket as a guide and mark the holes locations on the mounting surface.