44
English
Serial-ATA Port 1
This item allows you to enable/disable the Serial-ATA Port 1.
Ø
The choice: Enabled or Disabled.
IDE Prefetch Mode
The onboard IDE drive interface support IDE prefetching for faster drive
access. If you install a primary and /or secondary add-on IDE interface,
set this field to Disabled if the interface does not support prefetching.
Ø
The Choice: Enabled or Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or mul-
tiple sector read/write. If your IDE hard drive supports block mode(most
new drivers do), select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can support.
Ø
The Choice: Enable or Disabled.
Onboard SuperIO Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
Onboard FDC Controller
This item specifices onboard floopy disk drive controller. This setting
allows you to connect your floopy disk drives to the onboard floopy
connector.
Ø
The Choice: Enable or Disabled.
Onboard Serial Port1
This option is used to assign the I/O address and interrupt request(IRQ) for
the onboard serial port1(COM1).
Ø
The Choice: Disabled, 3F8-IRQ4, 2F8-IRQ3, 3E8-IRQ4, 2E8-IRQ3,
or Auto.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O
address and interrupt request(IRQ).
Ø
The Choice: Disabled, 378/IRQ7, 278/IRQ5 or 3BC/IRQ7.
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available mode.
Ø
The Choice: SPP, EPP, ECP or ECP+EPP.
