30 User's Manual
On-Chip Primary PCI IDE
As stated above, your system includes two built-in IDE controllers, both of which
operate on the PCI bus. This setup item allows you either to enable or disable the
primary controller. You might choose to disable the controller if you were to add a
higher performance or specialized controller.
On-Chip Secondary PCI IDE
As above for the Primary controller, this setup item you either to enable or disable the
secondary controller. You might choose to disable the controller if you were to add a
higher performance or specialized controller.
Onboard PCI SCSI Chip
This items allows you to set your onboard Adaptec PCI SCSI adapter in use or not. By
default, this item set to enable.
This item will not show up when your main board is HOT-559S.
Onboard FDC Control
This item specifies onboard floppy disk drive controller. This setting allows you to
connect your floppy disk drives to the onboard floppy connector. Choose the "
Dis-
abled
" settings if you have a separate control card.
Onboard Serial 1
This item is used to define onboard serial port 1 to
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4,
2E8/IRQ3, Auto
or
Disabled
.
Onboard Serial 2
This item is used to define onboard serial port 2 to
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4,
2E8/IRQ3, Auto
or
Disabled
.
UR2 Mode
The main board support IrDA(HPSIR) and Amplitudes Shift Keyed IR(ASKIR) infrared
through COM 2 port. This item specifies onboard Infra Red mode to
IrDA 1.0, ASKIR,
MIR 0.57M, MIR 1.15M, FIR
or
Standard (Disabled).
Note : FIR is not available currently.
IR Duplex Mode
This item specifies onboard infrared transfer mode to
full-duplex
or
half-duplex. This
item will not show up when IrDA, ASKIR, or MIR UR2 modes are selected.
Onboard Parallel Port
This item specifies onboard parallel port address to
378H, 278H, 3BCH
or
Disabled.
