![background image](http://html1.mh-extra.com/html/shure/scm410e/scm410e_user-manual_1262112007.webp)
7
SCM410 CONNECTIONS
1.
Connect microphone signal sources to the Channel Input connec-
tors. Use conventional 2-conductor shielded audio cables.
2.
If any condenser microphones are connected, set the +12V phantom
power DIP switch to ON.
3.
Connect the SCM410 Mic/Line Level Output to the input of mixers,
EQs, amplifiers or recorders.
4.
Connect the power cord to 100-120 Vac (SCM410) or 220-240 Vac
(SCM410E)
LINKING MULTIPLE MIXERS
If more than four inputs are needed, multiple Shure SCM410, FP410,
or SCM810 mixers can be linked by connecting the LINK OUT of the
first mixer to the LINK IN of the next mixer, and so on. See Figure 2.
Leave the LINK IN jack of the
first
mixer and the LINK OUT jack of the
last
mixer unconnected.
When properly linked, the mixers will operate as a system. Automatic
mixing functions will be shared by all units. All input signals appear at
all linked mixer outputs. Each mixer's Master level control only controls
its own output. However, actual off-attenuation will increase as more
mixers are linked. This reduces excessive noise and reverberation
contributed by the increased number of microphones.
IMPORTANT:
When using logic terminals on linked mixers,
connect the LOGIC GROUND terminals of each unit together.
NOTE:
SCM410 link connections are unbalanced. To minimize
hum and noise, avoid using longer link cables. Use high
quality, shielded cable, and keep them away from sources of
magnetic or electrical noise, such as power transformers or
light dimmers. To minimize ground currents, make sure linked
mixers are connected to the same AC power mains.
SHURE
OR
LINKED SCM410 AND SCM810 MIXERS
FIGURE 2
Summary of Contents for SCM410E
Page 35: ......