Shure SCM268E, User Manual, Page: 6 / 28

6
Installation
Supplied Hardware
• 4 rubber feet. For stand-alone installation.
• 1 rackmount bracket, long. For half-rack (single unit) installations.
• 1 rackmount bracket, short. For half-rack (single) or dual-mount
installations.
• 2 straddle brackets. For dual-mount or fixed installations.
• 12 bracket screws, 1/4 in. (6 mm). For securing the brackets to the
chassis.
• 4 rackmount screws, 1 in. (2.5 cm). For mounting the unit in a rack.
• 4 plastic washers. For use with the supplied rackmount screws.
• 4 wood screws, 1/2 in. (1.25 cm). For fixed installations.
Bracket Screw
Rackmount Screw
Wood Screw
Rackmount Installation
The SCM268 can be mounted as a single unit or dual-mounted with either
another SCM268 or another Shure half-rack unit such as the SCM262
or DFR11EQ. Attach the rackmount brackets using one of the following
methods:
Single-unit (half-rack) installation:
1. Attach the short and long rackmount brackets to the
SCM268 with eight (8) of the supplied bracket screws.
Dual-mounted installation:
1. Connect the two units together side-by-side using two (2)
straddle brackets. The brackets should straddle the re-
cessed edges on the top and bottom of each chas-
sis. Fasten them using eight (8) bracket screws.
Be sure to use both straddle brackets-one on the top and one on the bottom.
2. Attach the short rackmount brackets to the outsides of the
combined units with eight (8) of the bracket screws.
3. After attaching the brackets, mount the unit in an equipment rack
using the supplied rackmount screws and plastic washers.
Stand-Alone Installation
Adhere the four (4) supplied rubber feet to the bottom of the unit at each
corner. This will keep it from sliding and protect the table surface.
Fixed Installation
To permanently affix the SCM268 above or below a table, shelf, or counter
top, use the following steps:
1. Fasten the straddle brackets to the recessed edg-
es of the chassis using four (4) bracket screws.
Top mount: Fasten the straddle brackets to the bottom of the unit.
Hanging mount: Fasten the straddle brackets to the top of the unit.
2. Fasten the straddle brackets to the surface us-
ing the four (4) supplied wood screws.
Top Mount
Hanging Mount