6
Viewing the Video Stream
Once components are connected, the video stream can be
monitored for camera set up and management during the
conference.
• If the video is displayed on an analog system, simply
connect the camera's video output to a computer, TV,
recorder with a video input jack.
• To view the video from the tablet or another computer on
the network, a video encoder must be connected to the
router.
A video encoder is required to view the cameras
through the camera control application.
Video Encoder
Video encoders enable remote access and control of an
analog video signal over an IP network. The encoder
connects to the camera or camera switcher with a coaxial
cable, converting analog signals into digital video streams.
The digital stream is accessible for viewing on the tablet or
recording from a computer.
Important:
a video encoder is required for viewing the video
picture on the camera control application.
To connect a video encoder to the Shure Camera Control
system:
1. Use a coaxial cable to connect the encoder to the video
output on the camera or video switcher.
2. Power the encoder with a power supply or PoE injector.
3. Connect the encoder to the router with a network cable.
4. Assign the following IP address to the encoder:
192.168.10.91
.
1
2
3
4
1
2
IRRX
IRRX
IR
ID
NX-1200
NETLINX
I/O
TX
TX
RX
1
2
1
2
3
4
SERIAL
MASTER
CONFIG
CONFIG
LINK/ACT
STATUS
OUTPUT
INPUT
RX
Linksys E3200
9:43 PM
Verizon
100%
Setup
Layouts
Camera Controller
NETWORK
Connected
OPEN MICS
0
SEAT NUMBER
25
Select Seat
25
Test Preset
Save
Delete
ZOOM
SPEED (1 - 20)
CAMERA VIEWS
2
3
4
1
10
EXTRON
ISS 506
Video signal over WiFi for viewing
on the app
Camera control signals
Analog video output
IP network with digital video signal
Encoder
Video Encoder with the CP 7980 Camera System
The encoder adds video to the IP network
Summary of Contents for CP 7890
Page 13: ......